How to Clean and Care for Your Moissanite Engagement Ring - Moissanite Engagement Rings

GUIDE · 3 MIN READ

How to Clean and Care for Your Moissanite Engagement Ring

The short version: warm water, a drop of dish soap, a soft toothbrush, two minutes. Once a fortnight if you wear it daily, more often if you cook or apply hand cream a lot.

That's all most rings ever need. Below is the longer version, plus what to actually avoid.

What's in this post
  • The home clean (2 minutes)
  • What to avoid
  • Does moissanite cloud?
  • When to bring it in
  • Lifetime stone and craftsmanship warranty

The home clean (2 minutes)

  1. Fill a small bowl with warm (not hot) water and one drop of plain dish soap.
  2. Drop the ring in. Let it sit for 5-10 minutes so the build-up loosens.
  3. Brush gently with a soft toothbrush. Focus on the back of the stone (the pavilion), which is where hand cream and soap film build up. Get under the prongs and behind the gallery.
  4. Rinse under cold water. Plug the sink first.
  5. Dry with a lint-free cloth.

That's the whole routine. No ultrasonic, no steam, no chemicals. You don't need any of that for a clean stone in good prongs.

What to avoid

  • Chlorine. Pool, spa, hot tub. Chlorine attacks the alloys in 18K gold (especially anything with copper) over time. It's not instant, but repeated exposure dulls the metal and weakens claws. Take the ring off.
  • Bleach and household cleaners. Same issue. Rubber gloves don't fully protect; just take it off.
  • Gym, gardening, beach, climbing. Sand and grit are abrasive. Weights and bars chip stones. Take it off.
  • Sleeping in it long-term. Optional. Most clients do. It does mean more frequent prong-checks.
  • Ultrasonic cleaners at home. Fine for the stone, can loosen prongs over time on older settings. Get it done at a jeweller who'll re-check the setting after.

Does moissanite cloud?

No. The stone itself is stable and won't yellow, fog, or lose sparkle. If your ring looks dull, it's almost always build-up on the pavilion. Two minutes in soapy water fixes it.

When to bring it in

Once a year for a proper check. We look at the prongs, the shank, and clean it in our ultrasonic with a fresh inspection. It's free for any ring we made. Takes 20 minutes if you wait.

Also bring it in straight away if:

  • A prong feels rough or sharp against your other fingers
  • The stone clicks or moves when you tap it gently
  • You've taken a hard knock against something solid

Lifetime stone and craftsmanship warranty

Every ring we make is covered by a lifetime stone and craftsmanship warranty, with normal wear excluded. If the stone ever chips or cracks, we replace it. Re-plating is separate but we handle that too.

Need a check-up or clean? Book an appointment at the Southbank studio. Level 7, 80 Dorcas St. Visits are by appointment only, including quick cleans.

Back to blog